Bluetooth users manual

AudioBahn Speaker Manuals. AudioEngine Speaker Manuals. AudioSource Speaker Manuals. Audiovox Speaker Manuals. AutoTek Speaker Manuals. Avalon Acoustics Speaker Manuals. Axiom Audio Speaker Manuals. Bazooka Speaker Manuals. Behringer Speaker Manuals. Belkin Speaker Manuals. Benwin Speaker Manuals. The speaker turns off automatically if it is not paired in 5 minutes.

Turn the speaker off, then back on to re-enter pairing mode. A tone sounds and the LED blinks quickly. If your speaker does not enter pairing mode, press and hold the function center button on the top of the device for 1 to 3 seconds to put your speaker in pairing mode. If none of the above solve your issue, your battery might be defective.

If you are using an aux cable to connect your device, make sure the cable is fully plugged into the speakers and there is no debris in the aux port. If you are connecting with bluetooth, make sure you are within the device's range, 30 feet 9. If you've tried all of the above, your speakers might be damaged. If the device is connected to the AUX-in jack, you're going to have to use your device to control the volume.

Anritsu Bluetooth Headset Manuals. Avaya Bluetooth Headset Manuals. Axxess Interface Bluetooth Headset Manuals. Baracoda Bluetooth Headset Manuals. Belkin Bluetooth Headset Manuals. Black Box Bluetooth Headset Manuals. Blackberry Bluetooth Headset Manuals. Bluetake Technology Bluetooth Headset Manuals. BlueTrek Bluetooth Headset Manuals. Bose Bluetooth Headset Manuals.

Brookstone Bluetooth Headset Manuals. Once your earphone is paired to a specific cell phone, they will remain paired and automatically recognize each other whenever they are within range.

The red color LED indicator turns blue when full charged. Make sure that your earphone is fully charged for at least 3 hours before initial use. Warning: You must select a qualified charger from a regular Manufacturer. You must charge the earphone if it has been not used for more than 1 month. Operation is subject to the following two conditions: 1 This device may not cause harmful interference, and 2 this device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:.

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.