Coaxial termination tool

This tube runs coaxially over the signal conductor. Maintaining the integrity of this shielding tube requires a special crimp termination method for coax.

Use these tips to …. Save with MyShopping. Also important is the type of terminal being crimped because each type of terminal has a specific crimp profile. Insulated or Non-Insulated.

Need help? Sign In. Brands Hellermann Tyton Signamax Inc. Brands Platinum Tools, Inc. Fire Protection. Safety Equipment. Fiber Optic. Cable Management. Network Products. None of the wires should be blocking the white insulation.

Cut the conductor wire if necessary. Most cable stripper tools will leave the correct length of conductor wire exposed, but it doesn't hurt to double check before proceeding. The exposed connector cable should be 3. Put the connector onto the stripped end of the cable. Use a pusher tool to firmly push the connector onto the cable until the white insulation is flush with the connector.

Make sure you avoid bending the bare conductor wire when installing the connector. You may need to twist the cable while pushing with the tool to get it firmly connected. Compress or crimp the connector.

The process for compressing or crimping the connector varies depending on the type of connector you are using. Some require you to press down on the cable-end of the connector piece, while others require you to push the front and end of the connector piece into each other. Squeeze the compression or crimping tool firmly. Most tools won't allow you to over-compress, but some can cause damage to the cable and connector if compressed too much. Inspect the connection for imperfections.

After you have finished compressing the connector, inspect it for any stray wires or loose connections. These can lead to a bad signal or nonfunctional cable. Can you tell me how to remove these compression connectors, and can it be done without a special crimping tool?

Get regular pliers and place the jaws on the "humps" on the crimped connector and squeeze slightly. There are usually four "humps," so you would do this once on each pair. If this does not work, simply cut off the end. Then you would strip the end again to attach a new connector.

These connectors cannot be reused, but can be replaced by "twist-on" connectors which do not need a tool. Yes No. Not Helpful 0 Helpful 3. Include your email address to get a message when this question is answered. By using this service, some information may be shared with YouTube. Use one brand of cable for your whole project.

Helpful 5 Not Helpful 2. There are several different types of coaxial cable and connectors. Helpful 6 Not Helpful 4. If the coaxial cable has a foil shield underneath the braided shield, you want it cut to the same dimensions as the braided shield. Helpful 4 Not Helpful 3. Submit a Tip All tip submissions are carefully reviewed before being published. You Might Also Like How to. How to. Co-authors: 8.